Getting Started with X-Lite Softphone
X-Lite SIP Phone Download it here:
The Quick Start Guide and User Manual can be found here.
The Quick Start Guide and User Manual for X-light 3.0 can be found here
How to Configure the Service ?
On the X-Lite program. Click on the MENU button (on the right of CLEAR
and on the left of the green button),
Select System Settings, SIP Proxy, Default. And enter the following info:
| Enabled: |
Yes |
| Display Name: |
Robert |
| Username: |
18993001005 (the account number we provide) |
| Authorization User: |
18993001005 (the account number we provide) |
| Password: |
Account password |
| Domain/Realm: |
sip.myvoipaccount.net
|
| SIP Proxy: |
sip.myvoipaccount.net
|
Configuration Screens for X-Lite
Enter the configuration data by pressing the MENU button (located at the right of the CLEAR button), System Settings, SIP Proxy, Default. As seen on the following image:
|
Click "BACK" at the bottom left of the menu pane to save the settings.
ONLY IN CASE OF STATIC IP ADDRESS, In the Primary DNS and
Secondary DNS fields on the Network page, enter DNS server
IP address as provided to you by your ISP.
To test the service dial a regular phone number.
How to Configure the Service for V3.0?
|
|
| Display Name: |
Robert |
| Username: |
18993001005 (the account number we provide) |
| Password |
Voip password provided by swissipcom |
| Authorisaton User name |
18993001005 (the account number we provide) |
| Domain |
sip.myvoipaccount.net
|
|
|
Domain proxy:
1- enable "register with domain and receive incoming calls"
2- enable "target domain" under "sent oubound via"
3- click on "apply" than "OK"
Troubleshooting:
If you are have problems of registration or one way audio, please follow these steps:
For Full cone NAT routers:
a- click on menu>>sip account settings>>properties>>topology
b- enable "use specified server" and type stun.counterpath.net
c- click OK
For Symmetric NAT routers:
a- click on menu>>sip account settings>>properties>>topology
b- enable "port used on local computer" than manually specify range as 8000-8010
c- click OK
d- access your router and forward port range from 8000 to 8010 to the ip address of your PC where your x-light
V3.0 is installed.
|
|
|
|
|
|
|
| |
|
|
